Sub-zero 427R User Manual download pdf (Page 29)

Models 427 and 427R Installation 29

subzero.com

Side Panels

ide panels for models 427 and 427R are not attached to

the unit. You must securely fasten the panels to adjacent

cabinets and floor.

Panels should be fastened to the floor and walls using ‘L’

brackets (hardware not provided). To help you move the

unit into place, rout out an area in the floor so the ‘L’

bracket will sit flush with the floor level.

Anchoring

Brackets and screws are provided for mounting the unit to

adjoining cabinets and side panels. Each unit has four

side-mounting clips on each side.

IMPORTANT NOTE: For installations where you are not

attaching to a side wall, or you are installing two model

427, 427R or integrated units together, you must remove

the side-mounting clips before moving the unit into

position. After removing the clips, replace the screws into

the appliance.

A dual installation heater kit is necessary for anchoring

two model 427, 427R or integrated units together. The kit

is available through your authorized Sub-Zero dealer, or

call Sub-Zero at 800-222-7820. You can also visit our

website at subzero.com.

Complete the Installation

IMPORTANT NOTE: When you have completed the instal-

lation of the model 427 or 427R wine storage unit, refer to

page 54 for an installation checklist and page 55 for

service information.

90° door stop.

90° Door Stop

odels 427 and 427R have a 90° door stop built into the

hinge system. Use the blade edge of a standard screw-

driver and rotate the brass cam in the center portion of

the hinge until you reach the stop. You must make this

adjustment to both the bottom and top hinge. Refer to the

illustration below.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

No comments

Sub-zero 427R User Manual Page 29