Sub-zero 427R User Manual download pdf (Page 22)

Lock Installation

or models 427 and 427R, the optional lock is attached

to the decorative door panel through a field-drilled hole in

the panel. The catch should be installed on the top of

appliance cabinet before the unit is moved into position.

The accessory lock kit and additional instructions are

available through your authorized Sub-Zero dealer, or call

Sub-Zero at 800-222-7820. You can also visit our website

at subzero.com.

IMPORTANT NOTE: For accessory stainless steel panels

requiring a lock, panels must be ordered with the lock

mounting hole pre-drilled.

Position the Unit

Remove the decorative top and side moldings and the

kickplate/grille of the wine storage unit.

IMPORTANT NOTE: If for any reason the wine storage unit

has been laid on its back or side, you must allow the unit

to stand upright for a minimum of 24 hours before con-

necting power.

Plug the power cord into the 15 amp grounded electrical

outlet. With power applied to the appliance, check for

lighting and cooling before going any further. Once you are

satisfied that the unit is operating properly, shut off power

to the electrical outlet at the circuit breaker and proceed.

Models 427 and 427R Installation 22

f a home alarm system is to be used with the wine

storage unit, the lead wires should be threaded into the

compressor compartment before you position the unit.

Refer to wiring connections on page 24 for the location of

these lead wires. After the unit is in position, the alarm

wiring can be completed from the front.

Pre-level the wine storage unit before rolling into position.

This is to allow the unit to engage the anti-tip bracket

properly.

Roll the unit into position, making sure the anti-tip bracket

is engaged properly. Screw the front leveling legs out

approximately

/16" (5) to make any future adjustments

easier.

IMPORTANT NOTE: When the wine storage unit is

installed, the anti-tip bracket will be positioned just below

the engaging bracket on the unit. It is not necessary to

raise the unit up so that it locks into the anti-tip bracket,

but the unit must be in alignment with the anti-tip bracket.

IMPORTANT NOTE: The floor under the wine storage unit

must be at the same level as the surrounding finished floor

to allow for removal of the unit for servicing.

Shut off the power to the electrical outlet.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Comments to this Manuals

No comments

Sub-zero 427R User Manual Page 22

Comments to this Manuals

Related products and manuals for Water equipment Sub-zero 427R