Sub-zero 427R User Manual download pdf (Page 10)

Models 424 and 424FS Installation 10

Lock Installation

IMPORTANT NOTE: I

f you are adding an accessory lock kit

to your wine storage unit, it should be installed before you

position the unit.

The accessory lock kit and additional instructions are

available through your authorized Sub-Zero dealer, or call

Sub-Zero at 800-222-7820. You can also visit our website

at subzero.com.

POSITION THE UNIT

IMPORTANT NOTE:

If for any reason the wine storage unit

has been laid on its back or side, you must allow the unit

to stand upright for a minimum of 24 hours before con-

necting power.

Plug the power cord into the 15 amp grounded electrical

outlet. With power applied to the appliance, check for

lighting and cooling before going any further. Once you are

satisfied that the unit is operating properly, shut off power

to the electrical outlet at the circuit breaker and proceed.

f a home alarm system is to be used with the wine

storage unit, the lead wires should be threaded into the

compressor compartment before you position the unit.

Refer to home alarm connections on page 11, for the

location of these lead wires. After the unit is in position,

the alarm wiring can be completed from the front.

Pre-level the wine storage unit before sliding it into

position. Leveling cannot be completed with the unit

pushed back in the installation opening.

For model 424FS, adust the leveling legs so the top of the

unit is no more than 34

/8" (879) above the floor. This is to

allow the unit to engage the anti-tip bracket properly.

Center the model 424FS in front of the anti-tip bracket.

Slide the unit into position, making sure the anti-tip

bracket is engaged properly.

IMPORTANT NOTE: When the wine storage unit is

installed, the anti-tip bracket will be positioned just below

the engaging bracket on the unit. It is not necessary to

raise the unit up so that it locks into the anti-tip bracket,

but the unit must be in alignment with the anti-tip bracket.

The wine storage unit provides the best access to its

contents when the front surface of the door panel extends

out from surrounding cabinets approximately

/4" (6). For

model 424FS, if there are no surrounding cabinet surfaces

to gauge depth, slide the unit back until it engages the

anti-tip bracket.

IMPORTANT NOTE: The floor under the wine storage unit

must be at the same level as the surrounding finished floor

to allow for removal of the unit for servicing.

Shut off the power to the electrical outlet.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Comments to this Manuals

No comments

Sub-zero 427R User Manual Page 10

Comments to this Manuals

Related products and manuals for Water equipment Sub-zero 427R