Sub-zero 427R User Manual download pdf (Page 23)

Leveling

evel the unit by turning the front leveling legs clockwise

to raise the unit, or counterclockwise to lower it. To assist

you in adjusting the front leveling legs up or down, use a

standard screwdriver blade and place it in the front

leveling leg as shown in the illustration below.

The rear leveling legs are adjusted from the front of the

base by turning the Phillips head screw. Refer to the

illustration below.

IMPORTANT NOTE: The rear leveling legs will only move

/16" (2) for every 18 revolutions on the Phillips head

screw. Do not over torque. Use the lowest torque setting

on any power screwdriver. Do not turn the rear leveling

legs by hand. Damage will occur if you turn these legs.

Models 427 and 427R Installation 23

subzero.com

Install Molding

he decorative white molding strips for the top and sides

of models 427 and 427R can be snapped into place as

shown in the illustrations below. The top molding piece

must be installed before the side molding can be

attached. For installations where units are positioned side

by side, refer to side panels on page 29.

Front leveling legs. Rear leveling legs.

To reduce the possibility of the unit tipping forward, the

front leveling legs must be in contact with the floor.

TOP

MOLDING

Top molding. Side molding.

SIDE

MOLDING

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

No comments

Sub-zero 427R User Manual Page 23