Sub-zero IC-27FI User Manual download pdf (Page 12)

Integrated Installation 12

Position the Unit

lug the power cord into the grounded electrical outlet.

With power applied to the appliance, check for lighting

and cooling. Press the UNIT ON/OFF key pad on the

control panel (POWER for column models). Refer to the

illustrations below. Once you are satisfied that the unit is

operating properly, shut off power to the electrical outlet at

the circuit breaker and proceed.

If two integrated units are installed closer than 2"

(51) to

one another, refer to dual installations on page 20.

Pre-level the unit before moving into position. This is to

allow the unit to engage the anti-tip bracket properly.

Slide the unit into position, making sure the anti-tip

bracket is engaged properly. Extend the front leveling legs

down approximately

/16" (5) to make additional adjust-

ments easier.

When the integrated unit is installed, the anti-tip bracket

will be positioned just below the engaging bracket on the

unit. It is not necessary to raise the unit up so that it locks

into the anti-tip bracket, but the unit must be in alignment

with the anti-tip bracket.

The floor under the integrated unit must be at the same

level as the surrounding finished floor to allow the com-

pressor tray to be slid forward for service.

UNIT

ON/OFF

On/off key pad—tall model. On/off key pad—drawer model.

DER

MER

EFRI

GERA

EEZ

COLDER

/OFF

UNIT

ON/OFF

Level the Unit

evel the integrated unit by turning the front leveling legs

clockwise to raise or counterclockwise to lower the unit.

To assist you in adjusting the front leveling legs up or

down, use a standard screwdriver blade and place it in the

front leveling leg as shown in the illustration below.

The rear leveling legs are adjusted from the front of the

base by turning the Phillips head screw as shown in the

illustration below.

IMPORTANT NOTE: The rear leveling legs will only move

/16" (2) for every 18 revolutions on the Phillips head screw.

Do not over torque. Use the lowest torque setting on any

power screwdriver. Do not turn the rear leveling legs by

hand.

Once the unit is leveled, secure the unit in place by using

the side mounting clips and #8 x

/2" screws provided.

Front leveling legs. Rear leveling legs.

To reduce the possibility of the unit tipping forward,

the front leveling legs must be in contact with the floor.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Sub-zero IC-27FI User Manual Page 12

Comments to this Manuals

Related products and manuals for Refrigerators Sub-zero IC-27FI